Linear DXS-62/EC Manuel d'utilisateur télécharger pdf

DXS-62/EC

DXS-63/EC

SUPERVISED

EMERGENCY

TRANSMITTERS

Operation Instructions

PRODUCT DESCRIPTION

The Models DXS-62 and DXS-63 are battery powered, miniature,

water-resistant*, supervised transmitters designed for use in emergency

applications with Linear’s DX and DXS Format receivers. Each is supplied

with a wristband, a pocket clip, and a Nylon pendant necklace. Pressing

buttons on either transmitter sends a digital coded wireless signal to its

companion receiver. To insure sending a complete signal,

press the transmitter button(s) for a minimum of two

seconds.

Each DXS transmitter is factory set to a unique code, so no ﬁ eld coding

is required. The one-button DXS-62 sends a signal when its button is

pressed. The two-button DXS-63 transmitter sends a signal when both

buttons are pressed together. These transmitters can send a signal for

up to 30seconds per activation. The red signal indicator on the transmitter

lights and a built-in sounder beeps when the unit is activated.

If status transmissions are enabled, they will be sent every two hours.

Some receivers are able to use these signals, others are not.

Every two hours the transmitter tests for a low battery. This test takes

place even if status transmissions have not been enabled. If the battery

tests low, the transmitter sounder will beep and a low battery signal will

be sent.

Receivers must be programmed to the transmitter’s code before system

testing and operation. Refer to the receiver’s instructions for details on

operation and programming.

Each transmitter is sealed to provide water-resistance. The unit’s battery

is not replaceable. The transmitter should be discarded at the end of its

battery life.

* NOTE: Water resistance not tested by UL

FEATURES

WRISTBAND INSTALLATION PENDANT HOLDER INSTALLATION POCKET CLIP INSTALLATION

STATUS OPTION & PROGRAMMING SYSTEM TESTING INTERNATIONAL WARRANTY

This Linear product is warranted against defects in material and workmanship for twelve (12)

months. The Warranty Expiration Date is labeled on the product. This warranty extends only

to wholesale customers who buy direct from Linear or through Linear’s normal distribution

channels. Linear does not warrant this product to consumers. Consumers should inquire

from their selling dealer as to the nature of the dealer’s warranty, if any. There are no obligations

or liabilities on the part of Linear Corporation for consequential damages arising out

of or in connection with use or performance of this product or other indirect damages

with respect to loss of property, revenue, or proﬁ t, or cost of removal, installation, or

reinstallation. All implied warranties, including implied warranties for merchantability and implied

warranties for ﬁ tness, are valid only until Warranty Expiration Date as labeled on the product.

This Linear Corporation Warranty is in lieu of all other warranties express or implied.

For warranty service on Linear equipment return product, at sender’s expense to:

Linear Hong Kong 19/F Hounor Industrial Centre, 6 Sun Yip Street Chai Wan, Hong Kong

Attention: Repairs Department

REPAIRS POLICY



Charges will be made for equipment that is not in warranty, shows customer abuse, or is

damaged by the effects of lightning, water, ﬁ re, or other abnormal happenings.

 Customer’s equipment sent in for repair may be repaired or replaced with new or remanufactured

equipment at Linear’s discretion.



The customer is always responsible for shipping and handling charges to the repairs facility.

Linear will pay return shipping and handling charges on “in warranty” products shipped back

to the customer. The customer will be billed for the return shipping and handling charges on “out

of warranty” products.



There will be a 50% expedite fee for any express requests.



The International Sales Manager must be notiﬁ ed prior to the return of product to Linear. All

international returns must have an International Repair Authorization number (IRA#). The number

must be marked on all packages. Failure to do so will cause delays in processing.

IMPORTANT !!!

 Linear radio controls provide a reliable communications link and ﬁ ll an important need in portable

wireless signaling. However, there are some limitations which must be observed.

 The radios are required to comply with local rules and regulations as radio devices. As such, they

have limited transmitter power and therefore limited range.

 A receiver cannot respond to more than one transmitted signal at a time and may be blocked

by radio signals that occur on or near their operating frequencies, regardless of code settings.

 Changes or modiﬁ cations to the device may void regulatory compliance.

 Infrequently used radio links should be tested regularly to protect against undetected interference

or fault.

 A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale

distributor or dealer, and these facts should be communicated to the ultimate users.

(760) 438-7000 • FAX (760) 438-7043

www.linearcorp.com

NOTE: NECKLACE SIDE OF PENDANT HOLDER

FITS CLOSEST TO THE SIGNAL INDICATOR

TO INSTALL PENDANT HOLDER, SLIDE HOLDER

INTO SLOTS ON ENDS OF TRANSMITTER

INSTALL THE PENDANT HOLDER

THEN CUT AND REMOVE THE NECKLACE

SNAP THE POCKET CLIP

INTO THE PENDANT HOLDER

BEEP... BEEP...

BEEP

IF THE FOUR HOUR STATUS TIMER IS REQUIRED FOR

SUPERVISION, PERMANENTLY ENABLE THE TIMER BY

PRESSING THE TRANSMITTER BUTTON FIVE TIMES IN

SUCCESSION (USE THE LEFT BUTTON ON DXS-63). THE DXS-62

WILL BEEP AFTER EACH BUTTON PRESS, THE DXS-63 WILL

NOT. FIVE BEEPS WILL SOUND WHEN THE TIMER IS ENABLED.

PROGRAM THE TRANSMITTER INTO THE RECEIVER BY

PLACING THE RECEIVER INTO PROGRAM MODE, THEN SEND

A SIGNAL TO THE RECEIVER FROM THE TRANSMITTER.

REFER TO THE RECEIVER'S PROGRAMMING INSTRUCTIONS

FOR DETAILS.

NOTE: THE END OF STRAP WITH VELCRO ATTACHES

TO THE END CLOSEST TO THE SIGNAL INDICATOR

TO INSTALL WRISTBAND, SLIDE STRAPS

INTO SLOTS ON ENDS OF TRANSMITTER

BEEP...

IMPORTANT! TEST SYSTEM WEEKLY

The manufacturer strongly recommends that you test

security equipment frequently. Over a period of time, no

electronic products are better than the inspection and

maintenence they receive. Therefore, from the time of

installation, it is absolutely necessary to test the system

at least once a week.

PLACE THE RECEIVER IN A "TEST"

MODE AND ACTIVATE THE

TRANSMITTTER. VERIFY THAT THE

SIGNAL IS RECEIVED AND THAT THE

SYSTEM REPORTS AS REQUIRED.

DXS-62

DXS-63

ACTIVATION

BUTTON

SIGNAL

INDICATOR

ACTIVATION

BUTTONS

(PRESS BOTH)

PENDANT HOLDER

NYLON

NECKLACE

POCKET

CLIP

WRIST

STRAP

PRINTER’S INSTRUCTIONS:

INSTR,INST,DXS-62,63/EC - LINEAR P/N: 215558 D - INK: BLACK - MATERIAL: 20 LB. MEAD BOND - SIZE: 8.500” X 11.000” - SCALE: 1-1

DXS-62/EC 1
DXS-63/EC 1

Résumé du contenu

Page 1 - DXS-63/EC

DXS-62/ECDXS-63/ECSUPERVISEDEMERGENCYTRANSMITTERSOperation InstructionsPRODUCT DESCRIPTIONThe Models DXS-62 and DXS-63 are battery powered, miniature,

Modèles reliés DXS-63/EC

Commentaires sur ces manuels

Pas de commentaire

Linear DXS-62/EC Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Satellite Linear DXS-62/EC. Linear DXS-62/EC User Manual Manuel d'utilisatio

Résumé du contenu

Modèles reliés DXS-63/EC

Commentaires sur ces manuels

Produits connexes et manuels pour Satellite Linear DXS-62/EC