Linear DVS-2400 Manuel d'utilisateur télécharger pdf (Page 14)

Black 0014

Black0014

6. BASIC CONSOLE PROGRAMMING

◆

In a new installation,

when power is first applied

the Console’s master user code is “1234”.

CREATE THE MASTER USER CODE

✍

NOTE: Local programming must be entered on the

Console’s keypad, not on a wireless remote keypad.

Press [

∗

] (clears keypad if any other keys have

been pressed).

Place the Console in Test Mode (enter 1234 and

press [

TEST

].

❇

A “gong” and four “beeps” will sound.

Enter the Setup Mode

from Test Mode

, enter

1234

then press [

TEST

] again.

❇

A “gong” and five “beeps” will sound. You are

now in Setup Mode.

Enter 99 then press [

HOME

].

Enter any combination of 1-5 digits for the

master user code, then press [

AWAY

].

✍

NOTE: For maximum security, a three to five digit

code is recommended.

Press and hold the [

OFF

] key for 3 seconds to

exit program mode.

Test the new master user code by entering it

then pressing [

TEST

].

Log the master user code in the box below.

MASTER USER CODE

✍

NOTE: The master user code can be used to enter

Setup Mode. The restricted user codes cannot. To

create restricted user codes, see the “Advanced

Programming” section of this manual.

PROGRAM THE SENSORS INTO THE CONSOLE’S MEMORY

◆

Each wireless sensor that is going to be used

with the Console must be programmed into the

Console’s memory.

Start with the Console in Test Mode (enter any

user code and press [

TEST

]).

Enter the Setup Mode

from Test Mode

, enter the

master user code

then press [

TEST

] again.

❇

A “gong” and five “beeps” will sound. You are

now in Setup Mode.

❇

The sensor status indicators will light for any

sensors programmed into the Console.

Enter an unused sensor number from 01-24

(you must enter two digits, example: 5 = 05)

❇

The sensor indicator light will flash for the sensor

number selected.

Activate the sensor by sending a test or alarm

signal (be sure the sensor’s battery is connected

or that its battery protection strip is removed).

❇

A single “bing” tone will sound and the sensor

status indicator for that sensor will stay lit.

Enter another sensor number or exit Setup Mode

by holding the [

OFF

] key for three seconds.

START IN OFF

DEFAULT

MASTER

USER

CODE

1 GONG &

4 BEEPS

(TEST MODE)

START IN SETUP

PROGRAMMING

STEP #99

NEW

MASTER

USER

CODE

DONE

HOLD FOR

3 SECONDS

TO EXIT

SETUP

STORE

CODE

ENTERING

SETUP

MODE

CLEARS

KEYPAD

DEFAULT

MASTER

USER

CODE

1 GONG &

5 BEEPS

(SETUP MODE)

SETTING A

NEW MASTER

USER CODE

PROGRAM

START IN TEST

MASTER

USER

CODE

1 GONG &

5 BEEPS

NEW

SENSOR

NUMBER

ACTIVATE

SENSOR

DONE

TEST

12

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Commentaires sur ces manuels

Pas de commentaire