Linear RE-1 Manuel d'utilisateur télécharger pdf (Page 12)

OPTIONAL KEYSWITCH

A keyswitch can be installed in the RE-1 Entry System to provide

keyed access. The RE-1 case is designed to accept the following

keyswitch:

KNOX COMPANY MODEL 3501

KNOX COMPANY

800-552-5669

www.knoxbox.com

Keyswitch Installation

1. Disconnect the wiring harness connector and remove the antenna

terminal block. Remove the four circuit board retaining screws and the

RE-1 circuit board (see Figure 18).

2. Remove the screw and washer that retain the keyswitch hole access

plate (see Figure 19).

3. Hold the lock cover and plastic spacer in place on the RE-1 case.

Secure the assembly with four screws, lock washers, and nuts. Slide

the keyswitch into the hole, oriented as shown (see Figure 20).

Secure the keyswitch with the large switch nut. Use bolt cutters to trim

the two screws closest to the case edge so they will clear the circuit

board (see Figure 21).

4. Plug the two keyswitch snap-on wire leads (supplied with the switch)

onto the keyswitch COM and N.O. pins (see Figure 21).

5. Replace the RE-1 circuit board. Secure the board with the four

screws. Reconnect the antenna terminal block and wiring harness

connector.

6. Connect one keyswitch wire to the RE-1 OPEN #1 terminal. Connect

the other keyswitch wire to the RE-1 COMMON terminal.

DISCONNECT THESE

TWO CONNECTORS

REMOVE THESE

4 SCREWS

REMOVE

CIRCUIT

BOARD

Figure 18. Removing the RE-1 Circuit Board

REMOVE THE

SCREW AND

WASHER

REMOVE THE

COVER PLATE

INSTALL COVER PLATE

AND SPACER WITH FOUR

SCREWS, LOCKNUTS, & NUTS

SPACER

COVER

PLATE

ASSEMBLY

INSERT KEYSWITCH

INTO HOLE WITH

KEYSLOT ORIENTED

AS SHOWN

Figure 20. Installing the Keyswitch

COM

N.O.

SWITCH

PINS

CONNECT SWITCH WIRES

TO COM AND N.O. PINS

SWITCH SECURED

WITH LARGE NUT

BOLTS CUT SHORT

TO CLEAR CIRCUIT

BOARD

Figure 21. Keyswitch Wire Connections

ACCESS

KEYSWITCH

OPEN #1

KEYPAD GND

KEYPAD DAT 1

KEYPAD DAT 0

KEYPAD PWR

TRANSFORMER

BATTERY NEGATIVE

BATTERY POSITIVE

SENSE #1

COMMON

KEYPAD CLK

KEYPAD DVAL

OPEN #2

RE-1

TERMINALS

SENSE #2

NOTE: THE KEYSWITCH CAN BE WIRED TO

THE OPEN #2 TERMINAL TO CONTROL

A SECOND GATE OR DOOR

Figure 22. Keyswitch Wiring

Figure 19. Removing the Keyswitch Hole Access Plate

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Linear RE-1 Manuel d'utilisateur Page 12

Commentaires sur ces manuels