Linear RE-1 Manuel d'utilisateur télécharger pdf (Page 7)

ENTRY SYSTEM MOUNTING

Pedestal Mounting

The RE-1 Entry System can be mounted on a standard pedestal.

1. Open the RE-1 case by removing the two security screws with the

wrench provided (see Figure 2).

2. Use four security bolts and locking nuts to secure the backplate to the

pedestal (see Figure 3).

Wall Mounting

The RE-1 Entry System can be mounted directly to a wall or ﬂ at

surface.

1. Open the RE-1 case by removing the two security screws with the

wrench provided (see Figure 2).

2. Use the appropriate fasteners to secure the system’s backplate to the

mounting surface. When mounting the system to a concrete wall, use

concrete wedge anchors (see Figure 4).

TELEPHONE WIRING

The RE-1 connects between the incoming telephone line of the

residence and local telephone sets.

Telephone Bypass Module

The RE-1’s Telephone Bypass Module provides surge protection and

a switch to remove the RE-1 from the telephone line and re-connect

the local telephones to the telephone system. ALL TELEPHONE

WIRING FOR THE RE-1 MUST PASS THROUGH THE BYPASS

MODULE.

The bypass module is housed in a weather-resistant enclosure and

should be located in an area that is easily accessible to the resident.

In case of system trouble, the resident can use the bypass switch to

remove the RE-1 from the telephone system.

Telephone Wiring

• DO NOT ROUTE TELEPHONE AND AC WIRING INSIDE THE SAME

CONDUIT. Route all telephone wires inside a dedicated conduit that is

at least six inches away from any AC line wiring.

• All telephone wiring must be made on the “house” side of the telephone

company’s demarcation device (the terminal block where the telephone

line connects to the residence).

• If any security system or personal alert system at the residence is

connected to the telephone line, be sure that it is connected to the line

ahead of the Telephone Bypass Module using a RJ-31X or RJ-38X

interface.

• Use only high-quality telephone wire rated for direct underground

burial. All telephone wire should be twisted-pair with a minimum size of

24 AWG.

Typical Telephone Wiring

1. Connect the bypass module’s EARTH GROUND terminal to a good

earth ground.

2. Before connecting the incoming telephone line to the bypass module

check the polarity of the wires with a DC voltmeter. Connect the

negative wire (RING - usually green) to the bypass module TELCO

RING terminal. Connect the positive wire (TIP - usually red) to the

bypass module TELCO TIP terminal.

3. Connect the resident’s local telephone line RING (usually green) to

the bypass module HOUSE RING. Connect the local telephone line

TIP (usually red) to the bypass module HOUSE TIP terminal.

4. Connect the RE-1 TELCO RING to the bypass module RE-1 TELCO

RING terminal. Connect the RE-1 TELCO TIP to the bypass module

RE-1 TELCO TIP terminal.

5. Connect the RE-1 HOUSE RING to the bypass module RE-1 HOUSE

RING terminal. Connect the RE-1 HOUSE TIP to the bypass module

RE-1 HOUSE TIP terminal.

Figure 4. Wall Mounting Backplate

Figure 3. Pedestal Mounting Backplate

REMOVE THE TWO

SECURITY SCREWS

TO OPEN THE CASE

Figure 2. Opening the RE-1 Case

Figure 5. Telephone Wiring

PEDESTAL

MOUNTING

MOUNT BACKPLATE

WITH SECURITY BOLTS

AND LOCKNUTS

PEDESTAL

CAUTION!

BE SURE THE MOUNTING HARDWARE

DOES NOT EXTEND MORE THAN 1/2"

INSIDE THE BACKPLATE OR

ELECTRICAL DAMAGE MAY OCCUR

CASE

GROUND SCREW

USE WEDGE ANCHORS

FOR CONCRETE OR

OTHER APPROPRIATE

ANCHORS FOR DIFFERENT

MATERIALS

WALL

MOUNTING

CAUTION!

BE SURE THE MOUNTING HARDWARE

DOES NOT EXTEND MORE THAN 1/2"

INSIDE THE BACKPLATE OR

ELECTRICAL DAMAGE MAY OCCUR

GROUND

STAKE

TIP

RING

TIP

RING

TIP

RING

TIP

RING

TELCO

RE-1

TELCO

RE-1

HOUSE

TELCO

RING

TIP

RING

TIP

EARTH

HOUSE

TELEPHONE

BYPASS

MODULE

EARTH

GROUND

TO HOUSE

PHONES

TO TELCO

LINE

RE-1

ENTRY

SYSTEM

TELEPHONE

BYPASS

MODULE

CASE

GROUND

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Linear RE-1 Manuel d'utilisateur Page 7

Commentaires sur ces manuels